lubricating oil造句

lubricating oil造句

• 1、The state of the fuel oil,lubricating oil, cooling fresh and sea water, and bilge system.(燃油、滑油、冷却水、海水和舱底水系统的情况。)
• 2、They have paid close attention to the market for mid-gradelubricating oil and have adopted the strategy of "cutting into the sales of mid-gradelubricating oil".(外国石油公司已经密切关注中档油市场，开展了“下攻中档油”的策略。)
• 3、The result showed that the removal rate of this type of gelling agent to gasoline, diesel oil, kerosine andlubricating oil was higher than 90%.(结果表明，此类凝油剂对汽油，柴油，机油以及基苯及苯系有机溶剂等的去除率达90％以上。)
• 4、The optimal weight fraction is 0.1%, for under this condition, the wear scar diameter is decreased 35.6% andlubricating oil has great time-release effect.(当铜镍复合粉体的质量分数达到0.1%时，磨斑直径降低幅度最大，达35.6%，并具有很好的长效减摩性能。)
• 5、In the paper, the Neural Network model of metal content mainly monitored in thelubricating oil monitoring system of aeroengine is built by the method of Neural Network.(利用神经网络方法对某型航空发动机滑油监控系统中需重点监控的金属元素含量建立了网络，并根据该模型对其含量变化趋势进行了预测分析。) [hao86.com好工具]
• 6、An airplanelubricating oil injection gun comprises an oil storage cylinder plug (1), a decomposed joint (2), a cloth clamping hose (3) and an oil injection nozzle (4).(一种飞机滑油注油枪，其包括储油筒堵头(1)、分解接头(2)、夹布胶管(3)、注油嘴(4)。)
• 7、With the increasing soot level contaminatinglubricating oil, the oil viscosity increase and wear of engine components become more severe. And it shortens the life of engine.(柴油机油引起的粘度增长不仅缩短了柴油机的使用寿命，而且增加了零部件的磨损。)
• 8、In this paper, the design of both the software and the hardware of the computer control system for the test-bed oflubricating oil system for aeroengine are discussed explicitly.(本文详细讨论了航空发动机滑油系统试验台计算机控制系统的软、硬件设计的过程和方法。)
• 9、lubricating oil of the low pressure system supplies the main and other bearings.(低压系统的滑油供给主轴承和其它轴承。)
• 10、The application of time-series modeling and forecasting method to the spectral analysis forlubricating oil of mechanical equipment is discussed.(讨论了时序建模与预测方法在机械设备滑油光谱分析中的应用。)
• 11、The article forlubricating oil into dry gas seal reason is analyzed.(本文针对干气密封一次进油事故原因进行了分析。)
• 12、With CD40lubricating oil as work medium, under the engine cooling system work conditions, 21 geometrical schemes of stainless steel offset strip fins were studied.(采用CD40柴油机油为工作介质，在发动机冷却系统实际工况下，对21种几何尺寸的错列锯齿型不锈钢翅片进行了研究。)
• 13、Taking DF4B locomotive as an example, this paper analyses the reason of too lowlubricating oil pressure in running diesel engine, and gives countermeasures for it.(以DF4B型机车为例，系统地分析了造成柴油机机油压力低的原因，并提出其判断方法和对策。)
• 14、The testing process was used CD40lubricating oil and CD40lubricating oil appending nano-Cu additive.(试验结果证明纳米铜添加剂能够有效改善柴油机的磨合质量，缩短磨合时间。)
• 15、The toxicity oflubricating oil and grease 'chiefly stem from additives and stuff. Its main harm is dermatitis.(润滑油、脂的毒性主要来源于添加剂和填充物，其主要危害是皮炎。)
• 16、It is one of the most important problems to assurelubricating oil of returning to the compressors all the time.(保证冷冻油源源不断地返回压缩机是制冷系统设计中最重要的课题之一。)
• 17、As thelubricating oil passes over a hot engine part, it removes a certain amount of heat.(当机油经过发动机的热的部件时，它将带走一定量的热量。)
• 18、In this paper, we discuss the applications of time series modeling method in the analysis oflubricating oil of mechanical equipment.(本文讨论了时序建模方法在机械设备滑油光谱分析中的应用。)
• 19、Afterwards in meets in the fast box the replenishment 20lubricating oil.(随后在接速箱内加注20号机械油。)
• 20、Three preparation methods for fluorocarbonlubricating oil and its properties and applications are introduced in this paper.(介绍了全氟碳油的产品性能及应用情况。)
• 21、The problems such as noise, abnormal sound, heat andlubricating oil leakage of front gear box of DF 8b locomotive are analyzed in detail.(对东风8B型机车前变速箱存在的噪音、异音、发热和机油泄漏等问题，进行了详尽的分析。)
• 22、Test results proved that, in the process of using oil, the light oil content inlubricating oil can be judged from the decreasing degree of flash point.(试验证明：在油品使用过程中，从闪点的下降程度可以判断混入轻质油的含量。)
• 23、lubricating oil inside the engine produces a film on the moving parts.(发动机内部的机油在运动部件上形成一层膜。)
• 24、The higher the normal load, the smaller the effect of thelubricating oil inlet temperature and rolling speed on the traction coefficient.(随着载荷增大，入口油温和滚动速度对拖动系数的影响减小；)
• 25、Fuel oil andlubricating oil sy stems including pumps, purifiers, filters, heaters.(滑油管系，包括泵、分油机、滤器、加热器和管系状况满意，无泄漏。)
• 26、lubricating oil is designed to effectively carry away the excess heat being produced.(机油有效地带走发动机多余的热量。)
• 27、Previously, this problem was avoided by using a large amount oflubricating oil during machining.(为解决这一问题，以往是使用大量切削油进行切削加工。)
• 28、Alubricating oil pump shaft and a CAM transmission shaft are respectively sheathed in series in two inner cavities.(两内腔内分别串套机油泵轴和凸轮传动轴。)